3.5hp 2-stroke Fishing Inflatable Boat Motor Engine Shaft Cdi Water Cooling
This item has been shown 0 times.
3.5hp 2-stroke Fishing Inflatable Boat Motor Engine Shaft Cdi Water Cooling:
Notice:Please add gear oil to the gears before use the motor and replace gear oil after the run-in period(10 hours).(if you do not know how to handle this,please contact us).our outboard motor doesn't with oil of gear,please prepair it by yourself .Keep in mind that you must add oil on the gear beofore use !!!
1.About the noise: all the gasoline machines are noisy, currently we did not test the decibel , but the noise is the same as the motorcycle, so it is a normal phenomenon.
2.The machine itself is lightweight, it can use on boat weight of 100kg or less , load-bearing 4 people, but the speed is certainly not the same whenone person on it or 4 people on it . Customer who has high expectations on speed, please be noticed.
3.It can be marched with inflatable boats, rubber boats or fishing boats.
4.Necessary: you have to prepare a boat-motor stand or Hanging board on your boat.
We can only provide CE certification, there is no other certification can be provided,thanks for your understanding.
What you will receive is our new version of this boat engine
The trademark will be Yadao instead of Speeda.
Full throttle perating range:4000-5000r/min
Ignition system:CDI system
Starting system:Manual start
Staring carburetion system:Choke start
The engine and the propeller ratio:2:1
Recommended fuel:Regular unleaded gasoline
Fuel to oil ratio: 35:1 （Please be suject to this version, and disregard the manual about this point）
Gear ratio: 27/13
When at normal cruising,the appearance of the seventh picture. Falling back the boat, the appearance of the outboard motor likes the eighth picture . Falling back the boat, you should drive slowly otherwise the boat will not stable. The outboard motor backet can revolve 360. Only in
simple let the engine revolve 180 and the operation handle face back,the boat can fall back to drive.
After in the sea water or turoffer water cruising
1.Use the fresh water cleaning the outboard motor
2.With the moderate velocity circulating the engine,cool off the water chanel with fresh water.
3.Before completely running out cooling water,don't put the outboard motor outside. Otherwise the water cam pass the exhaust port to enter the
air cylinder, from that will cause the engine breakdown.
4.The engine should deposit in the aridity and ventilated well place,avoid exposing directly in the sunshine.
5.Before the long term storing,you should run out of the gasoline in the fuel tank.
- We maintain high standards of excellence and strive for hundred percent customer satisfaction. response is very important to us. We hope that you contact us immediately before you give neutral or negative response, so that we can address your concerns. It is impossible to address issues if we do not know about them!