"ff-3" A Tether Car By Beast Picco Power For Sale


"FF-3" a Tether Car by Beast !! I built this car to resemble one of the early mid engined formula race cars of the '60s but mostly like a Formula Ford. To get the look of the car right I had to make it front wheel drive and make the gearbox out of brass so that the car would balance. The rear dummy gearbox is attached to the backcase of the engine as is the full size car. Both rear wheels are free wheeling on two bearings for each wheel. The whole car is milled from 6061T-6 aluminum billet, no castings are used except for the engine.
The engine is the Picco P-zero .8cc (.061) converted from R/C car with a custom venturi and Enya needle valve. These engines are rated at 35,000 rpm on 20% fuel. The engine is new and comes with the box, paper work, R/C carb and whatever else was in the box. The custom flywheel is made of aluminum to save weight on the back of the car.
The 3/16ths drill rod drive shaft/pinion gear shaft enters the gearbox riding on two bearings. The gears are from HPI Racing with a 2:1 ratio, press fit onto their shafts with the axle gear pinned in place. The drill rod axle rides on two bearings as well.
The wrap around fuel tank should hold almost 1/2 ounce of fuel for plenty of running time ! The 6 inch pan handle is made from 1/8th inch thick steel. Grade 8 fasteners are used throughout except for the fuel tank and body screws which are stainless. The custom exhaust is functional.
Interior of the body has been glass bead blasted for a nice satin finish, everything else has been given a nice polish. The polish made getting really sharp photos a little difficult! What you see is what you get, a great looking car for your shelf or desk, plus you can take it out and run it !!length 8 3/8 inches
width 3 1/2 inches (less pan handle)
wheel base 5 3/4 2 5/8 inches
tire diameter 1 5/8 inches (solid rubber)
weight 1 pound 1 ounceAlso included with the car and engine box is two of my T shirts and an extra pair of tires !!Please read...payment is expected within three days of the sales end. I will send an invoice
when the sale ends. If you haven't made payment after two days I will send you a reminder
invoice. If payment is still not received after four (4) days, then an automatic non-paying
buyer dispute will be opened. Talk to me !Shipping....will only be via Priority Mail, no exceptions to anywhere. Shipping to the USA
will be $20 with full insurance included.
International shipping will be at cost plus a $2 handling fee, usually about $45 but may be more, I will send you an
invoice. You are responsible for any customs duties and taxes your country may impose. DO NOT
ask me to mark the customs form as a gift or at a lower amount, I will not do it ! A copy
of the sale will be included in the box.sold as is, no returns, no refunds
PayPal only please
$20 Priority Mail to USA
all others at cost plus $2 handling fee




This item has been shown 0 times.

Buy Now

"ff-3" A Tether Car By Beast Picco Power :
$700




Cox Gas Powered Corvette Stingray Thimble Drome Tether Car 1964 Rare Blue Color picture
Cox Gas Powered Corvette Stingray Thimble Drome Tether Car 1964 Rare Blue Color


Beautiful Vintage Thimble Drome Prop Rod picture
Beautiful Vintage Thimble Drome Prop Rod


Cox??  Gas Powerd  57 Chevey  picture
Cox?? Gas Powerd 57 Chevey


Custom Hand Painted Race Driver Fits Ohlsson Rice Cox Champion Cars Limited Quan picture
Custom Hand Painted Race Driver Fits Ohlsson Rice Cox Champion Cars Limited Quan


Testor 049 Truck picture
Testor 049 Truck


Testor 049 Truck picture
Testor 049 Truck


Testor 049 Vw Bug picture
Testor 049 Vw Bug


57 Chevy Wen-mac 049 Car picture
57 Chevy Wen-mac 049 Car


Testors 049 Van picture
Testors 049 Van


Testors 049 Vw (new) picture
Testors 049 Vw (new)