Ruger 10/22 Threaded Barrel End, Plain To 1/2-28 Tpi - Made In The U.s.a. Black For Sale

---

Convert yournon threadedbarrel to a standard 1/2-28 thread for all your end of barrel accessories.

If you want to get the full funfactor out of your Ruger 10/22,you need to beable to mount any 1/2-28threaded accessory. You need this part to mount end of barrel accessories. Such as amuzzle brake, COMPENSATOR or an UNRESTRICTED fake SUPPRESSOR.

It slips over the muzzle and around the front sight. It is held in place with a fairly large set screw that is flush when tightened. Super simple and very effective for the .22LR round.

Fits the Ruger 10/22 carbine and takedown models.

The largest diameteris a little larger than thecurrent A2 Birdcage and similar devices.

This sale is forone (1)converter. You will need to purchase the end of barrel accessory and crush washer seperately.

This converter is made in the U.S. using the finest steel available. It has a Mil. Spec. black oxide finish for years of trouble free service.

The picture is of the converter mountedon a blank barrel. It is the part that surrounds the sight. To the left of that is the crush washer, then a Muzzle Brake

This may fit other barrels, but is intended ONLY for the Ruger 10/22 .22 Cal. plain muzzle.

This item is a lot less expensive than going to a machinist or gunsmith.Plus you can do it yourself in minutes, and it can be taken off quite easily.

*** Don't forget to get some crush washers (in another listing in our store) for when you change End of Barrel Devices***

It is your responsibility to know and follow all Federal, State, and local laws, rules, regulations, restrictions and legislation about purchasing/owning/using this product.

Don't forget to "like" us on Facebook and follow us on twitter.

This item has been shown 7750 times. Ruger 10/22 Threaded Barrel End, Plain To 1/2-28 Tpi - Made In The U.s.a. Black: $29