Screw Down Flat Shoe for 9/16\" Balusters
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Screw Down Flat Shoe for 9/16\" Balusters:
$2.59
Screw Down (Winged) Flat Shoe for 9/16\" Balusters
- Use a screw down flat shoe where the baluster is installed in a level run
- Can be used at the top and bottom of 9/16\" square iron balusters
- Will work with all balusters listed as 9/16\" square
- It comes with two 1\" wood screws
- The footprint of the shoe is 1-9/16\"
- 9/16\" square opening shoe
- 1\" tall
- Simple and easy installation
- #2 Phillips screwdriver required
- Powder-coated, high quality finish
- 100% Aluminumbuilt to last
- Nice clean decorative look
- Use 1 flat shoe for each baluster on a rake run & 2 flat shoes for each baluster on a level run
- Hides undesirable holes and gaps
The 9/16\"Screw Down design (Winged) iron baluster shoe is easier to install than a regular base shoe; Just screw it down on a flat surface and you’re all set. No hex key or epoxy glue needed.