Shellplate Bearing Kit For Dillon Xl 650 Hit Factor Shooting Supply


Shellplate Bearing Kit For Dillon Xl 650 Hit Factor Shooting Supply

This item has been shown 28197 times.

Buy Now

Shellplate Bearing Kit For Dillon Xl 650 Hit Factor Shooting Supply:
$10


The original Shellplate bearing kit for Dillon XL650 by Hit Factor Shooting Supply, LLC.

This kit eliminates the snap when the shellplate advances to the next position. When the shellplate snaps, gunpowder splashes out of the casing causing a mess on your press and inconsistent loads. This kit also smooths out the operation of your press. No permanent alteration of the press is necessary (occasionally the ejector wire requires tuning). Many users report more consistent and easier primer seating.

The photo shows the pieces that come in the kit - two high quality hardened steel thrust races, one needle bearing and one low mass detent ball. The bearing pack installs on the shellplate bolt. This will not affect the depth of seating of primers or require die adjustments.

Detailed instructions come with each our kits. We also maintain a FAQ with the latest tips and tricks for your press. You may want to check that out before purchasing a kit. Hit Factor Shooting Supply, LLC.

Our kits were featured in the Nov/Dec 2011 issue of Front Sight magazine.

How the low mass detent ball works:

Our Low Mass Detent Ball for the Dillon RL 450, RL 550, XL 650 and SL 900 is tough as nails. This phenolic ball is super hard, smooth and lightweight. It's approximately 7 times lighter than the factory steel ball and every bit as tough. The low mass detent ball has less momentum when it locks up with the shellplate. The material also absorbs vibrations much better than the steel ball. This detent ball is highly abrasion resistant and will not be cut or scared by the shellplate. These are industrial grade and used when strength and abrasion resistance is required.

No modifications are required to run this low mass ball on your press. Instructions are included for installing this item, it just takes a minute. Some folks have cut half a coil off of the detent spring to reduce pressure. We recommend giving our low mass detent ball a try, before modifying your press.

The best solution to this common problem is one of our other kits that includes a shellplate bearing,click here to see our store and all Shellplate Bearing Kits.Kits are available for RL 550, XL 650, SL 900 and Super 1050.

All of our kits and components are made in the U.S.A.

International customers please note: You are responsible for duty and any other import fees levied by your country. Estimated delivery date does not account for the amount of time the package takes to clear customs. Shipments toItaly seem to take longer (4-6 weeks)than the estimated date of delivery provides.



Shellplate Bearing Kit For Dillon Xl 650 Hit Factor Shooting Supply:
$10

Buy Now



Hornady #36 Lock-n-load Ap Progressive Press Shellplate Steel 392636 picture
Hornady #36 Lock-n-load Ap Progressive Press Shellplate Steel 392636


Hornady Modified Case.45-70 Government A4570 picture
Hornady Modified Case.45-70 Government A4570


Rcbs Full Length Die Set.17 Remington Fireball picture
Rcbs Full Length Die Set.17 Remington Fireball


Rcbs 86003 Little Dandy Fixed-charge Powder Rotor #3 picture
Rcbs 86003 Little Dandy Fixed-charge Powder Rotor #3


Rcbs 90279 Trim Pro 3-way Cutter 6mm Cal Automated Case Preparation picture
Rcbs 90279 Trim Pro 3-way Cutter 6mm Cal Automated Case Preparation


Hornady 546393 Series Iv Specialty Die Set picture
Hornady 546393 Series Iv Specialty Die Set