I found this to work quite well for 9mm as long as I didn't fill the tube more than half way (or you may have lap full of bullets) . But I was able to fix some of this problem by putting some stick on sandpaper where the bullet sets below the tube, to keep it from slipping off the plastic so easy. But I must say when it is all set up and working you can really produce, especially if you have one of your kids to keep it loaded so you don't have to stop:) This does allow you to keep a better eye on powder etc. because you are not reaching for another bullet to put in every stroke, and trying not to pinch your fingers.
Verified purchase: Yes | Condition: New
Not hard to set up, yet I find for the Pro1000, the fingers and housing get in the way. Not only do the rub and bump the primer holder, but the support bar of the press. Lots of adjustment needed constantly. I was personally much faster doing it by hand.
Verified purchase: Yes | Condition: New
works well. Be sure to buy the correct length.
Verified purchase: Yes | Condition: New
This makes things so much better and faster not focusing on inserting a bullet.
Verified purchase: Yes | Condition: New
Great for freeing up a hand
Verified purchase: Yes | Condition: Pre-owned
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Presses & Accessories
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Presses & Accessories