Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Clay Target Shooting
I got the small size Pachmayr # 2306 slip on for my Henry H006 Series lever gun. I use this type of pad more to increase length of pull from trigger to butt plate. With that in mind, it is important that the pad fits snugly and doesn't creep around beside the stock between shots. This Pachmayr performed perfectly on both counts. I have used slip on pads in the past that were more difficult to put on and gave similar performance. Take your time working the Pachmayr # 2306 onto your similar sized rifle and it'll do fine. The rubber from my older pad (not a Pachmayr) dry rotted off my Mossberg 12 GA within 30 years. The Pachmayr rubber grips on my S&W stayed fresh that whole time, so I expect similar durability from this Pachmayr brand recoil pad.
Verified purchase: Yes | Condition: New
I've had many of these over the years and I can recommend them for many reasons. First, it's much cheaper than a custom installed recoil pad. Second, it doesn't damage the value of a vintage weapon and third, it can be used on multiple weapons or re-used. I have actually worn these out, but it takes many years of abuse. Highly Recommended.
Verified purchase: Yes | Condition: New
I purchased primarily to get additional length added to the stock of my marlin lever action rifle. The fit is nice and snug, and I gained about an inch of length. the pad also does an excellent job of absorbing recoil. I am very satisfied.
Verified purchase: Yes | Condition: New
this pad is an excellent fit for a stock. it forms well to the stock with no overhang. it also is soft instead of hard like others .it buffers the recoil to minimum shock. I highly recommend
Verified purchase: Yes | Condition: New
fits my Marlin 336 perfectly! Also adds needed length to the stock.
Verified purchase: Yes | Condition: New