The collet was easy to set up, to grip the bullet just above the case neck. It grabs well enough to extract the bullet without damage except for the first couple while I was adjusting the tension. It is much more efficient than the hammer inertia puller. Highly recommended.
Verified purchase: Yes | Condition: New
Perfect for reloading when you want to salvage a piece of brass for another load or replace a bullet or such, no damage and very easyto use as long as you have a Hornady Camlock Bullet puller to use with it.
Verified purchase: Yes | Condition: New
This works very well. Leaves little or no mark. I have mainly used it on some 147 Milsurp I loaded in .308. They were a little tight to chamber so I pulled them sown to re-run in the size die. If I have a lot of rounds to pull or tips to protect, this is the way. If I only have a few, I use the impact puller, rather than set up the puller.
Verified purchase: Yes | Condition: New
Makes bullet pulling real easy, without powder spill.
Verified purchase: Yes | Condition: New
No reloader should be without a bullet puller and the one from Hornady works great! I have the collet's for 308, 223 and 6.5 creedmoor You stuck with what works and this flat out works. I highly recommend it
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Presses & Accessories
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Presses & Accessories