This product could beat Superman! Met all my expectations except that I could not mix and pour a 4 oz. mix into a detailed mold before it went off (2.5 MIN)! Too much detail so I switched to ONYX SLOW (5 MIN) to give me more time. Product (thin catylist) could be in a more friendly bottle...lots of dripping. The black unit was thicker and poured without any mess.
Verified purchase: Yes | Condition: New
Mix and pour as fast as possible, less than 20 seconds mixing, as the actual workable pot life is around 1 minute. Highly recommend degassing the A + B parts unmixed prior to mixing for best results. Taking all that into account though, incredible resin. Rotocasts very thick, one layer of this equals about four of 300 or 320. Cures hard and very heat resistant. It's hardness does make it a little brittle though, it can survive a fall, but a dull drill bit catching might crack an area of it.
Verified purchase: Yes | Condition: New
Worked as expected simple to use and sets up fast
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Resin Craft Molds & Supplies
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Resin Craft Molds & Supplies