Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Shotgun Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Shotgun Parts
Fairly easy install unless you have a Remington 870 Express (removing the detents are the biggest time consuming section of the installation.) in my case I also had to shorten springs came with it no biggie just takes a few minutes. Looking good and it did give me an extra five shells at 2 3/4. IMHO it looks good, but it is a bit longer than the barrel
Verified purchase: Yes | Condition: New
The 10-shot extension works great if you use the provided spring AND the original spring together. I found that the provided spring is not long enough and you'll be left with a couple shots in the mag that won't cycle. BUT, if you use your original spring and the place the original follower on it for the original spring to push against (the springs can't push on each other as there is not enough surface area), then it works perfectly. I would have given 5 stars if the provided spring was enough.
Verified purchase: Yes | Condition: New
The "TacStar +5 Magazine Tube Extension for the Remington 870", is a very good product. Very easy to install, works great, no feeding issues, Note; Most Remington's Have Two Small Dents in the Magazine Tube that Must be Removed or Pushed Out to fit the Shells Thru the Magazine Tube.
Verified purchase: Yes | Condition: New
I purchased for 3-gun match. It arrived did not work on newer 870 (3-gun modded) because mag tube dimples, but fit my older hunting 870. It ran flawless. Only complaint is the finish doest math a blued barrel, but looks great on matte finish (newer 870). I will remove dimples and instal on newer 870 this weekend. Beware if you have newer 870 dimples in the tube mag have to be removed.
Verified purchase: Yes | Condition: New
Great Extension. Really makes the rifle look better and adds capacity.
Verified purchase: Yes | Condition: New