2 Sealed Angled Flush Mount Rod Holders For Kayaks And Hardware And Instructions
This item has been shown 0 times.
2 Sealed Angled Flush Mount Rod Holders For Kayaks And Hardware And Instructions:
2 FLUSH MOUNT ROD HOLDERS FOR KAYAKS
2 FLUSH MOUNT ROD HOLDERS
You get 2 Flush Mount Rod Holders and all the hardware necessary to install them in your kayak. Our rod holders are totally sealed at the bottom and will not let water leak into your kayak.
Included in this set is:
2 Flush Mount Rod Holders(9 inches long)
Installed length is 8 inches because of the angle
6 Stainless Steel Screws and Locknuts
6 Tri Grip Rivets if you do not have access to the inside
Installation Instructions and Cut out template.
These will take you about30 minutes to install.
We offer a life time unconditional warranty on all of our products. If you have any problems or concerns, email us first and then send it back and we will repair or replace it at absolutely no charge.
While you are here, check out all the other great Paddlers Items we carry.
Leashes, Deck Kits, Paddle Keepers, Anchor Trolleys, Anchors, Bungee by the Foot, Pad Eye Kits, Stainless Hardware.
Thanks for looking and email us with any questions you have.