LEE 2 Cavity Mold C309-170-F 30 Caliber 30/30 30/06 308 170 Grain Bullet #90368

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

LEE 2 Cavity Mold C309-170-F 30 Caliber 30/30 30/06 308 170 Grain Bullet #90368:
$19.99

Lee Double Cavity Mold produces two .309 diameter 170 graingas check design flat pointbullets.

Lee aluminum molds are the best value in bullet molds. The blocks do not rust like cast iron molds, and are lightweight for less fatigue and ease of use.

This is the new style with the steel locating pins like the ones found on the 6-cavity molds.

You can also quicklyswitch to a different mold while casting, as it can be quickly heated by dipping the corner of the mold in the lead pot. No other pre-warming required or wasting time with bad cast bullets while waiting for the mold to come up to temperature.

Includes a Free Set of Handles.

Best of all, they\'re priced at what others charge for handles alone!

Brand New in the box and ready to ship. Thanks for looking, check out my other sales for other great deals onshooting supplies and reloading equipment by clicking the folowing link:

Visit my store, Shooting Supply!

This mold will pay for itself with the firsthundred bullets you cast.

For Buyer protection, I can only accept payment thru PayPal.

PLEASE BE SURE YOUR SHIPPING ADDRESS IS CORRECT WHEN YOU CHECK OUT, IT CAN NOT BE CHANGED LATER.

Thanks for looking, Mark

From the Lee website:

Lee mold blocks are machined from aluminum blocks because of its exceptional molding qualities. Aluminum molds heat up and cool down faster than iron or steel molds so good bullets can usually be produced after only a few casts. Lee molds produce bullets faster than iron or steel molds due to the minimized down time between casts. In addition, they are one-third the weight of iron or steel mold blocks for less fatigue during extended casting sessions. To ensure the best possible bullets, mold block halves are clamped together and then lathe-bored for unmatched roundness and size control. All Lee 1- and 2-cavity molds come with mold handles and hard anodized sprue plates. Weights given are Lee\'s weights with suggested alloy; actual weight may vary due to alloy mixture used.